"Can I do it myself without getting a PHD first?" Yes! @Sybilla Comes in a kit - available at Bunnings, Total tools, etc. Imagine that bolt indicated ...
"The eyebolt is supposed to go into the tailgate and screwed on from underneath" So that's why I think a nut rivet would work.The rivet size just depe ...
Ok - thanks Dave. I was wondering if I should take my nut rivets and depart. .I have a twin-layered Holden Rodeo tailgate where it would work - just ...
All good then. Just a thought. "whilst I fully support collecting tools" Totally agree with that @DIYGnome - sometimes buying tools that may be usefu ...
Hi @Sybilla I must admit to not fully understanding the problem @Sybilla - but regards the eyebolt attachment - what thread/diameter is it?I'm just ...
Afternoo @Noyade I am thinking its just a protective cover and to make it loook nicer. Your sketch works showing what I was meaning I havnt see that ...
Afternoon @Sybilla I think when I look at the rear of the tailgate and see the lock on the tray dioor, I was presuming that that button/key is a lock ...
Hello @Sybilla the plastic trim on the inner edge of the tail gate is removable, behind which is the structure of the door, partially removing the tri ...
Well @Noyade you are correct a Rivnut would simplify the process but would require yet another specialised tool, whilst I fully support collecting too ...
Afternoon @Noyade
I was wandering around Bunnings aisles earlier trying to figure out bits and pieces tha could be put to another use for your bedfra ...
"Can I do it myself without getting a PHD first?" Yes! @Sybilla Comes in a kit - available at Bunnings, Total tools, etc. Imagine that bolt indicated ...
"The eyebolt is supposed to go into the tailgate and screwed on from underneath" So that's why I think a nut rivet would work.The rivet size just depe ...
Ok - thanks Dave. I was wondering if I should take my nut rivets and depart. .I have a twin-layered Holden Rodeo tailgate where it would work - just ...
All good then. Just a thought. "whilst I fully support collecting tools" Totally agree with that @DIYGnome - sometimes buying tools that may be usefu ...
Hi @Sybilla I must admit to not fully understanding the problem @Sybilla - but regards the eyebolt attachment - what thread/diameter is it?I'm just ...
If your inlet valve is in good condition, then I'd recommend replacing the inlet seal, @Noyade. However, if the plastic is aging or has become brittle ...
